Téléchargement | - Voir le manuscrit accepté : Modeling and Optimization of the Hot Embossing Process for Micro and Nanocomponent Fabrication (PDF, 1.8 Mio)
|
---|
DOI | Trouver le DOI : https://doi.org/10.1117/1.2176729 |
---|
Auteur | Rechercher : Worgull, M.; Rechercher : Heckele, M.; Rechercher : Hétu, J. F.1; Rechercher : Kabanemi, K.1 |
---|
Affiliation | - Conseil national de recherches du Canada. Institut des matériaux industriels du CNRC
|
---|
Format | Texte, Article |
---|
Sujet | hot embossing; injection molding; plastic molding; nanocomponents |
---|
Résumé | Hot embossing and injection molding belong to the established plastic molding processes in microengineering. Based on experimental findings, a variety of microstructures have been replicated using these processes. However, with increasing requirements regarding the embossing surface, and the simultaneous decrease of the structure size down into the nanorange, increasing know-how is needed to adapt hot embossing to industrial standards. To reach this objective, a German- Canadian cooperation project has been launched to study hot embossing theoretically by process simulation and experimentally. The present publication reports on the proceeding and present first results. |
---|
Date de publication | 2006-03-01 |
---|
Dans | |
---|
Langue | anglais |
---|
Publications évaluées par des pairs | Oui |
---|
Numéro du CNRC | NRCC 48831 |
---|
Numéro NPARC | 15979203 |
---|
Exporter la notice | Exporter en format RIS |
---|
Signaler une correction | Signaler une correction (s'ouvre dans un nouvel onglet) |
---|
Identificateur de l’enregistrement | 0ccc2015-3d62-4bc5-8836-f4bf92c7b874 |
---|
Enregistrement créé | 2010-12-10 |
---|
Enregistrement modifié | 2020-04-22 |
---|