Deflashing of automotive formed parts : warpage and tolerance issues

  1. (PDF, 1 MB)
DOIResolve DOI:
AuthorSearch for: ; Search for: ; Search for:
Series titleSAE Technical Papers; no. 2006-01-0586
ConferenceSAE 2006 World Congress & Exhibition, April 03-07, 2006, Detroit, Michigan, USA
SubjectCAD / CAM / CAE; Simulation and Modeling; Finite element analysis; Forming
AbstractBlow moulding is one of the most important polymer processing method for producing plastic automotive parts. Yet, there are still several problems that affect the overall success of forming these parts. Among them, are thermally induced stresses, relevant shrinkage and part warpage caused by inappropriate solidification conditions. This work presents a finite element model that allows for predicting residual stresses and subsequent deformations that arise during the cooling stage of finished parts. It is expected that the virtual presence of the flash zone has an influence on the development of residual stresses in the numerical model. Deflashing is usually performed immediately after part removal from the mould, therefore, the numerical model is adapted to take this into account. Numerical results obtained with and without flash for a simple part, as well as a complex automotive part, are compared to determine accuracy and limitations of the model.
Publication date
PublisherSAE International
AffiliationNational Research Council Canada (NRC-CNRC); NRC Industrial Materials Institute
Peer reviewedYes
NRC numberNRCC 48836
NPARC number15877976
Export citationExport as RIS
Report a correctionReport a correction
Record identifierb596e049-f864-4950-b281-5c74d9d65656
Record created2010-07-30
Record modified2017-06-06
Bookmark and share
  • Share this page with Facebook (Opens in a new window)
  • Share this page with Twitter (Opens in a new window)
  • Share this page with Google+ (Opens in a new window)
  • Share this page with Delicious (Opens in a new window)
Date modified: