A Reference heat source for solar collector thermal testing

  1. (PDF, 1 MB)
AuthorSearch for: ; Search for:
ConferenceASME Winter Meeting: 1984-12, New Orleans, Louisiana, USA
Subjectsolar collectors; thermal testing equipment; materiel d'essai thermique
AbstractLiquid-based solar collectors have been tested using a direct-comparison reference heat source (RHS). An electric heater is installed in series with the solar collector under test. Energy is added to the heat transfer fluid at a measured rate by the RHS, and the rate of solar energy collection is determined as the product of this energy input and the ratio of the differential temperatures across the collector and the heater. The RHS and associated temperature sensors can be thought of as a thermal mass flow meter where, in effect, the product of mass flow and specific heat is measured directly in the test loop. Calibration tests were performed on two reference heat sources at various flowrates and at the temperatures normally encountered in flat plate solar collector testing ( approximately 10 degrees C to approximately 95 degrees C). Values of solar collector efficiency, the ratio of the measured RHS thermal power output to the fluid to the RHS electrical power input were determined for each case.
Publication date
AffiliationNRC Institute for Research in Construction; National Research Council Canada
Peer reviewedYes
NRC number24094
NPARC number20378575
Export citationExport as RIS
Report a correctionReport a correction
Record identifier7777b4f8-1b31-4db0-bf99-da1801f49ae8
Record created2012-07-24
Record modified2016-05-09
Bookmark and share
  • Share this page with Facebook (Opens in a new window)
  • Share this page with Twitter (Opens in a new window)
  • Share this page with Google+ (Opens in a new window)
  • Share this page with Delicious (Opens in a new window)
Date modified: