Residential total energy system installation at the Canadian Centre for Housing Technology

  1. (PDF, 722 KB)
AuthorSearch for: ; Search for: ; Search for: ; Search for: ; Search for: ; Search for: ; Search for:
ConferenceWorld Energy Engineering Congress: 15 August 2007, Atlanta, GA.
Pages19; # of pages: 9
Subjectresidential total energy system, cogeneration, ground source heat pump, Canadian Centre for Housing; Housing technology
AbstractThis paper describes a demonstration project that examined the feasibility of distributed cogeneration to satisfy the total energy needs of a house. It presents operational results of the heat pump system in heating mode. The residential total energy system consisted of: two one-ton ground source heat pumps; an air handler for supplemental/back-up heating; a natural gas fired hot water tank; an indirect domestic hot water tank; and, a multistage thermostat. The bore-field for the heat pumps consisted of three vertical wells arranged to suit a typical suburban landscape. Two of the wells served the heat pumps and the third well was arranged between the other two to sink the waste heat from a future cogeneration unit. The heat pump system was sized to satisfy the cooling load in Canada's heat dominated climate, leaving room in the operation of the system to accept waste heat from the cogeneration unit, either directly or indirectly, by recycling the heat through the ground to the heat pumps.
Publication date
AffiliationNRC Institute for Research in Construction; National Research Council Canada
Peer reviewedYes
NRC number50273
NPARC number20377104
Export citationExport as RIS
Report a correctionReport a correction
Record identifier29c2b346-c208-411f-b30c-14465f617505
Record created2012-07-24
Record modified2016-05-09
Bookmark and share
  • Share this page with Facebook (Opens in a new window)
  • Share this page with Twitter (Opens in a new window)
  • Share this page with Google+ (Opens in a new window)
  • Share this page with Delicious (Opens in a new window)
Date modified: